Step 1. Assemble the Hub Mount the meter on the rails inside of the enclosure. | |
Step 2. Locate a spot to mount the Hub
We recommend mounting the Hub close to a group of your machines to optimize the sensor connections. | |
Step 3. Clip the CT on the first phase of the machine’s power
Locate the power source of the machine. This is the spot where you will clip the CT sensor on Phase 1. You will know the sensor is fully clipped on when you hear two clicks. If you need to extend the length of the sensors, you can do so using Cat6 cable. | |
Step 4: Plug the CT sensor cable into the egauge meter
Next, connect each CT plug (2 pin) into any available port on the eGauge meter. Repeat for each sensor. | |
Step 5: Plug in the egauge meter Connect the power cord provided with the eGauge meter to a 110V outlet. Then insert the green connector side of that power cord into the meter input labeled "Power Vdc” as shown. | |
Step 6: Connect the egauge meter to the internet Insert SIM card and send the SIM number to your Technical Account Manager. Using the provided ethernet cable and splitter, connect the LTE router to the meter and the power cable. You will know that you are connected to the network when you see a heart and ethernet icon on the meter display screen: | |
Step 7: Repeat steps 3 and 4 for any additional machines Once the installation is complete, fill out the machine information file and share it with the Guidewheel team to complete the system configuration. |
This installation guide is provided by Guidewheel for informational purposes only. Please proceed with caution and use common sense when installing any equipment. By using this guide, you acknowledge and agree to the terms and conditions available at www.guidewheel.com/terms-and-conditions.